Undergraduate Course: Analogue Mixed Signal Laboratory 3 (ELEE09025)
Course Outline
School | School of Engineering |
College | College of Science and Engineering |
Credit level (Normal year taken) | SCQF Level 9 (Year 3 Undergraduate) |
Availability | Available to all students |
SCQF Credits | 10 |
ECTS Credits | 5 |
Summary | This course is an exercise in basic analogue electronic circuit design using discrete components and operational amplifiers. The exercise involves designing analogue circuits for the implementation of an end-to-end optical signal transmission through free-space and plastic optical fibre. The emphasis here will be on hands-on learning through experimentation. The fundamental properties of optical communications will be taught at the start of course; including signal attenuation in fibre, dispersion/pulse spreading and LED/Laser comparison and photo-detection.
The course is designed to use knowledge gained by students in the earlier years of their course and aims to act a "structured project". The course is structured so as to act as an introduction to the more open ended type of final year project work carried out in the fourth and fifth years. Until this point in the course the students experience is largely of analysis of circuits supplied to them. In this exercise students are expected to synthesise their own designs and realise their own circuitry.
Assessment of this course will be based on: (1) a written report by the students explaining their design and the function of each subsystem. This report will be expected to include the circuit diagrams, design equations and a complete list of components and their values. In addition, the report should contain student attempts to specific questions in the provided laboratory script. (2) The PCB layout, efficient use of space on the PCB, good soldering/component placement on the PCB. (3) Finally, the design functionality. It is expected that, with the implemented design, it should be possible to achieve an end-to-end optical signal transmission over 50 m plastic optical fibre and demonstrate ¿LiFi¿ audio signal transmission. Assessment is based on the measured performance metrics stated in the lab manual and quality of the ¿LiFi¿ audio signal transmission.
|
Course description |
Not entered
|
Information for Visiting Students
Pre-requisites | Familiarity with op-amp circuits, basic competence with electronic design, competence in the use of simple electronic test equipment. |
High Demand Course? |
Yes |
Course Delivery Information
Not being delivered |
Learning Outcomes
On completion of this course, the student will be able to:
- Be able to use discrete components and operational amplifiers to implement basic analogue designs and implement a multistage amplifier design which withstands the effects of inter-stage loading between successive stages
- Be able to design a trans-impedance (TIA) based optical receiver to a written specification and be able to balance the gain/bandwidth trade-off of their TIA design
- Be able to integrate optical transmitter and receiver design to form a complete working end-to-end optical communication chain. Then test their designs by transmitting analogue signals over the link and measure performance
- Be able to prototype their designs on a breadboard, layout their design using an appropriate software and implement a printed circuit board of their final design
- Be able to document the designs that they have carried out
|
Additional Information
Graduate Attributes and Skills |
Not entered |
Keywords | Electronics,design,laboratory |
Contacts
Course organiser | Dr Wasiu Popoola
Tel: (0131 6)50 8232
Email: |
Course secretary | Mrs Megan Inch-Kellingray
Tel: (0131 6)51 7079
Email: |
|
|